联系我们

新乡市恒通电机有限公司

联系人:张经理

电话:86-0373-2681999

传真:86-0373-2676888

邮 箱:xxshtdj@126.com

地 址: 新乡市牧野区

您当前位置: 首页 > 新闻中心 > 新闻中心

AEEVF3电机AEEV1H 品牌马达AEUVF3变频电机AEUV1H

[ 时间:2018-11-30   点击:755 ]

AEEVF3电机AEEV1H 品牌马达AEUVF3变频电机AEUV1H
新闻详情:

      AEEVF3电机AEEV1H 品牌马达AEUVF3变频电机AEUV1H 特种电机AEEFF3 电动机AEVFF3; TEGH(AEHB)/TVGH   AEEVJ3电机 AEEVJ2电动机 AEUVJ2 马达 AEUVJ3seven、motor maintenance 0.75HP 1HP 1.5HP 2HP 10HP 15HP 3HP 4HP 5.5HP 1/4HP 1/2HP 1HP
1. The environment, in which the motor is operated, should be kept clean and dry, air inlet should not be hindered by dust or fibers.
2. If the protective devices of the motor operate continuously, it should ascertain whether the fault is from overload operation, it can be put into operation again only after the fault has been eliminated.
3. Should ensure that the motor is in running with good lubrication, according to the different operation conditions, every 500~1000 hours or so, the grease should be
   added or replaced (for closed bearing the grease does not need to be replaced in the whole life). If the bearing is detected with overheating or lubricating grease
   deterioration during operation, should change the grease in time. When changing grease, the old grease should be removed ar first, the oil bearing and bearing cover
   of the oil tank need to be cleaned with kerosene, then grease 1/2 (level 2) or 2/3 (level 4,6,8) of the inner and outer cavity of the bearing.
4. At the end of the bearing life, the vibration and noise will increase when the motor is running, check the bearing radial clearance and replace the bearing.
5. Remove the motor, the fan should be removed first, from the non shaft extension (the back end) out of the rotor. Attention, do not damage the stator
   winding or insulation.
6. When the rotation direction of the motor does not meet the requirements, you can adjust the power phase sequence.
7. When the motor is holding for a long time after use, you should measure the insulation resistance.